A) LOAD BAR

Part #RP-037

Required for FREEDOM PIVOT™ on stationary machines or curved track systems.
36” x 2-1/2”

B) THREADED RODS (1/2" diameter)

Part #SP-021

Fully threaded rods can be cut to any length: cutting charges apply. May be obtained locally.

C) METAL FRAMING CHANNEL

Part #SP-022

To be used when mounting track in the same direction as the ceiling joist. This channel is mounted at a right angle to the ceiling joist to disperse the weight load. Available in 10 foot sections. 12 Gauge - 1 5/8” x 3 1/4”. May be obtained locally.

D) JOIST CLAMP

Part #SP-012

Height of clamp 7-3/4”. Size of joist 2”. Inside width 1-3/4”. Size of side bolt holes 7/16”. Bottom hole 9/16”. (comes in extra wide when doubling wood trusses, inside dim. is 3-3/4”)

E) "V" CLAMP

Part #SP-013

End holes 7/16” diameter: hole center 4-1/2”. Center holes 9/16” diameter.

F) "U" CLAMP

Part #SP-014

End holes 7/16” diameter: Centers hole 9/16” diameter. Drop 2-3/16”.

G) ANGLE IRON

Part #SP-023

Recommended for sway brace use. 1/8” thick, 1-1/4” leg length. 1 lb. per foot. 6’ lengths.

H) DOUBLE BRACKET PLATE

Part #SP-016

Holes in both horizontal and bent sides 9/16” diameter.

I) SINGLE BRACKET PLATE

Part #SP-017

Holes in both horizontal and bent sides 9/16” diameter.

J) "C" CLAMP

Part #SP-018

Bottom rod diameter 1/2”. Maximum flange thickness 3/4”. Hardened steel cup point set screw diameter 3/8”. Work load limit 540 lbs. Used with “I”-beams, channels and wide flange beams. Support rod is threaded into bottom tapped hole.